CHEMUNI联合化学Polycarboxylate ethers

Quality

A process you can audit beats a sentence about reliability.

The real risk in an overseas purchase is not a modest specification — it is batch-to-batch drift. This page states what we measure, what we judge against, how long we keep it, and what you can check at destination.

Six gates a batch passes

From raw material to retained sample

01

Raw material intake

Macromonomer sampled per lot for hydroxyl value, water and unsaturation; acrylic acid for purity and inhibitor content. A failing lot goes back — it does not enter the tank farm.

02

In-process control

Feed rate, reaction temperature and hold time logged per batch; conversion and viscosity checked mid-run. An out-of-band reading stops the line rather than travelling downstream.

03

Batch testing

Solids, pH, density, chloride and total alkali on every batch; viscosity and appearance as supporting criteria.

04

Application check

Paste flow and mortar water reduction are the release gates on performance; new formulations or changed raw materials trigger a concrete-level check as well.

05

Retained sample

At least 12 months of retained sample per batch, archived with the COA. If a question comes back from destination, this is the bottle that gets re-tested.

06

Traceability

A batch number traces back to the raw-material lot, the reactor, the shift and the inspection record. A complaint lands on one batch, not on "production around that time".

Standards we work to

Standard Scope
GB 8076-2008Concrete admixtures
JG/T 223-2017Polycarboxylate high-performance water reducers
ASTM C494/C494MType F and Type G chemical admixtures
EN 934-2Admixtures for concrete, mortar and grout

The standard numbers describe the test methods and the basis for judgement. Product is supplied to the contractual TDS, tested by the methods in those standards; where third-party reports are needed, testing goes to a laboratory recognised in the destination country.

The data you receive

Every COA carries measured values rather than a pass stamp. These five are always reported:

Solid content50 ± 1 %
pH at 25 °C6.0–8.0
Density at 25 °C1.07–1.11 g/cm³
Chloride≤ 0.05 %
Total alkali≤ 2.0 %

The ranges above are common to the standard grades; the grade TDS and the batch COA govern in each case.

Documents

Download or request, no account

TDS

A data sheet per grade: recommended dosage, typical values, scope and storage. Downloadable from the list below, or by email where not yet listed.

SDS

16-section GHS format, English in stock; other languages on request, stating destination and use.

COA

Supplied with the goods, or sent for approval before the container is loaded.

TDS by grade

PDF · six grades

Request SDS and other documents

Ask for a real COA

Name a grade and you get the last three batches. Batch-to-batch variation is easier to read in numbers than in adjectives.