CHEMUNI联合化学Polycarboxylate ethers

01 · Technical note

The same grade, two plants, two different results

Three things change between plants before the admixture ever does: the cement, the sand and the clock. Here is the order to check them in.

Start with the cement, not the admixture

A polycarboxylate adsorbs onto the surfaces of the cement particles and onto the hydration products forming on them. Change the clinker and you change both the surface area available and how much sulfate is in solution. Two cements of the same strength class can differ by a factor of two in C₃A, and by more than that in soluble alkali.

High C₃A consumes the soluble sulfate early. Once the sulfate is gone, the ettringite that should have formed does not, and the aluminates that come free adsorb the polymer's side chains. The mix loses flow before the truck leaves the plant. The fix is not more admixture — it is checking that cement's sulfate balance with the supplier.

Then the sand

Clay is the most common reason a dosage that worked last month fails this month. A sand with a methylene blue value of 2.0 g/kg will take a measurable share of the polymer out of solution before it reaches the cement. The same quarry can move from 0.8 to 2.4 over a season as the face advances.

Fines matter too, in the opposite direction. A sand that is four percent short of fines makes the mix harsh and raises bleeding, and no water reducer will make it flow like a well-graded sand.

Then the clock and the thermometer

Adsorption is a kinetic process. At 15 °C a mix may hold its slump for three hours; at 35 °C the same mix can lose it in forty minutes, because the hydration that consumes water and exposes new surfaces runs faster. Haul time is the other half of the same equation: the admixture is working while the truck is moving, and by arrival the polymer has been partly consumed.

Two plants with the same mix design and different results are usually not a product problem. They are a materials problem the product cannot see.

How to run the comparison

Change one variable at a time and hold the rest as constant as the site allows:

  • Same cement lot, same admixture lot, same water. If the result still differs, the difference is in the sand or the temperature.
  • Measure slump at the plant and again on arrival. The gap tells you whether you have a retention problem or a dispersion problem.
  • Run a paste flow test on the two cements at a fixed dosage. It takes an hour and separates the cement from everything else.
  • Record the temperature of the mix, not of the air. A 30 °C day and a 30 °C mix are different things.

Only after those four are on paper is it worth changing the grade or the dosage. Most of the time the answer is a blend ratio, not a different product.

Send us your numbers

Cement type, sand MB value, haul time and temperature. The reply carries a dosage and a blend ratio, not a referral to a local agent.